Skip to content
AutoTyreSize Decode a size

Thar OG alloy wheels: factory sizes, spare and upgrade advice

Quick answer18 inch alloys on LXT (255/65 R18), 19 inch diamond cut alloys on ZXT (255/60 R19)

WheelsFactory fitment3 door TharFull size spareChecked 13 Nov 2026

Independent owner guide. Not affiliated with Mahindra. Figures checked against the maker's published details; confirm on your vehicle's door sticker or manual.

Thar OG alloy wheels come in two factory sizes: 18 inch alloys with 255/65 R18 tyres on the LXT, and on the top ZXT, 19 inch diamond cut rims wearing 255/60 R19 tyres. The base AXT does not get alloys at all; it rides on 18 inch steel wheels.

"OG" carries two meanings at the tyre shop. Mahindra now sells the 3 door Thar under the name Thar OG, and many owners also say "OG alloys" when they mean the original wheels the factory fitted, as opposed to aftermarket rims. This page covers Mahindra Thar alloy wheels in both senses: the stock alloys on today's Thar OG and on the earlier 3 door Thar. For the five door version, see Thar Roxx alloy wheels.

Thar fitment card

Tyre size
255/65 R18 (AXT, LXT), 255/60 R19 (ZXT) on the current Thar OG
Wheels
18 inch steel (AXT), 18 inch alloy (LXT), 19 inch diamond cut alloy (ZXT)
Earlier base version
245/75 R16 on 16 inch steel wheels (AX, earlier AXT)
Earlier top version
255/65 R18 on 18 inch alloy wheels (LX, earlier LXT)
Tyre pressure (cold)
About 32 psi front and rear; the door sticker figure for your tyre rules
Spare
Full size on the tailgate: steel on AXT and LXT, alloy 255/60 R19 on ZXT
Front fog lamps
Not on AXT; fitted on LXT; LED with cornering function on ZXT
Grey 18 inch five spoke alloy wheel with an all terrain tyre on a boxy 3 door off road SUV in a workshop bay
Factory 18 inch alloys on the LXT carry 255/65 R18 tyres

Thar OG alloy wheels by variant

Factory wheels on the 3 door Thar
VariantWheelTyre sizeSpare
Thar OG AXT18 inch steel255/65 R1818 inch steel
Thar OG LXT18 inch diamond cut alloy255/65 R1818 inch steel with cover
Thar OG ZXT19 inch diamond cut alloy255/60 R1919 inch alloy
Earlier LX and LXT18 inch alloy255/65 R18Full size, matching size
Earlier AX and AXT16 inch steel245/75 R16Full size, matching size

So if someone at a used car lot says a 3 door Thar has "original alloys", they should be 18 inch on an LX or LXT, or 19 inch on a Thar OG ZXT. A 16 inch alloy or a 20 inch rim on this jeep is not factory fitment. Variant by variant tyre details: see Thar tyre size.

Why the 19 inch ZXT wheel does not lift the Thar

The 19 inch ZXT rim uses a lower profile tyre, so the outside diameter barely differs from the 18 inch setup. Work it out: 255/65 R18 has a 165.75 mm sidewall, giving 457.2 + 331.5 = about 789 mm overall. 255/60 R19 has a 153 mm sidewall, giving 482.6 + 306 = about 789 mm. Ground clearance, gearing and the speedometer reading do not change between these two factory sizes.

What does change is the feel. The 19 inch tyre has about 13 mm less rubber in each sidewall, so a big pothole on a broken village road reaches the cabin a bit sharper, and the rim edge sits closer to the rock when you crawl over a dry riverbed.

Steel spare on an alloy Thar

The LXT hangs its spare, a full size tyre, on a steel rim under a cover at the back, even though the four road wheels are alloys. Many owners think the dealer swapped something. It is the factory setup. The ZXT is different: its spare is a matching 19 inch alloy.

A steel spare is fine to drive on, since it carries the same tyre size. Wheel nuts for a steel rim and an alloy rim can have different seats, so ask the service advisor whether the tool kit nuts suit both rim types, and recheck their tightness at the next puncture shop after you swap.

Thar rim fitment numbers: PCD, bore, offset

Before buying any rim, get three numbers: PCD (bolt circle), centre bore and offset. We could not confirm the Thar PCD from two reliable sources, so this page leaves it blank. Read it from the owner's manual or ask the dealer, then check any rim against it with the PCD calculator.

Offset matters a lot on this jeep. The Thar has wide flares and short overhangs, so a rim that pushes the tyre outward can scrape the plastic liner at full steering or when the suspension compresses, and it adds load on wheel bearings. Ask the rim seller for the offset in mm and compare it with the factory wheel stamped on its inner face.

Looking after diamond cut Thar alloys

The machined face on LXT and ZXT wheels is a thin bright layer over bare metal, sealed with clear lacquer. Once that lacquer chips, water and road salt from coastal areas creep under it and white spots appear. Hose off mud after every trail or flooded road, wash with a gentle shampoo, and stay away from acid based rim cleaners.

Scrapes across the bright face are fixed only by re-cutting on a lathe, which removes a little metal each time. A rim that is bent or cracked from a deep pothole should be checked by a wheel repair shop, not just painted. Our page on diamond cut alloy wheels explains that finish.

Off road use with factory alloys

On trails, the alloy itself is rarely the weak link. Sidewalls are. If you drop pressure for sand or slush, drive gently, avoid sharp ledges, and pump back up before the highway. A tyre that slips on the rim at low pressure can lose its bead. If any wheel shows a crack, a dent in the rim lip or air loss at the bead, let a tyre shop examine it before any long run.

For the full list of rim types and how to choose one, start with our alloy wheels hub.

Questions owners ask

What does OG mean in Thar OG alloy wheels?

It can mean two things. Mahindra sells the 3 door Thar under the Thar OG name, and owners also say OG for the original factory wheels. Either way, the stock alloys are 18 inch on the LXT and 19 inch on the ZXT.

What is the Thar alloy wheel size?

The LXT, and the earlier LX, roll on 18 inch alloys shod with 255/65 R18 rubber. The Thar OG ZXT moves to 19 inch diamond cut rims carrying 255/60 R19 rubber. The AXT runs steel wheels.

Does the Thar AXT come with alloy wheels?

No. The Thar OG AXT uses 18 inch steel wheels, and earlier AX and AXT jeeps ran 16 inch steel wheels. Many owners later fit 18 inch alloys in the LX size of 255/65 R18.

Will Thar OG ZXT 19 inch alloys fit an LXT?

The two sizes differ by under a millimetre, roughly 789 mm each, and both are factory fitments on the same model. Still, confirm the bolt pattern, offset and nut type with the dealer before swapping, since we could not confirm every detail.

Why is my Thar spare a steel wheel when the others are alloys?

That is how the LXT leaves the factory: a full size steel spare under a cover on the tailgate. The tyre size matches, so you can drive normally on it. Only the ZXT gets a matching alloy spare.

Is a 20 inch rim a good idea for a Thar?

They are not a factory size. Low profile tyres on 20 inch rims ride harder, lose off road grip and are easier to damage on potholes. Hold overall height within 3 percent of stock and load index equal or higher if you go ahead.