Skip to content
AutoTyreSize Decode a size

Skoda Kushaq tyre pressure in psi, bar and kPa

Quick answer33 psi front and 33 psi rear, cold, on both the 16 and 17 inch sizes

Pressure2.3 barFill when coldChecked 13 Nov 2026

Independent owner guide. Not affiliated with Skoda. Figures checked against the maker's published details; confirm on your vehicle's door sticker or manual.

The Skoda Kushaq tyre pressure is 33 psi in all four tyres when they are cold, which is 2.3 bar. Classic+ cars on 205/60 R16 and Signature or higher trims on 205/55 R17 share that one number.

Skoda prints the approved Kushaq pressure on a printed tag glued to the Kushaq door frame by the driver seat, and the handbook repeats it. That sticker overrides any website, this one included, since it matches the exact tyre size your Kushaq was built with.

Kushaq fitment card

Tyre size
205/60 R16 (Classic+), 205/55 R17 (Signature and above)
Wheels
16 inch alloy on Classic+, 17 inch alloy on Signature, Sportline, Prestige, Monte Carlo
Load and speed
92H on 205/60 R16, 91V on 205/55 R17
Tyre pressure (cold)
Front 33 psi, rear 33 psi (2.3 bar); confirm on the door pillar label
PCD
5 x 100 mm, centre bore 57.1 mm
Rim width
6J x 16 and 6.5J x 17
Digital tyre pressure gauge pressed on the valve of a compact SUV alloy wheel at a petrol pump
Check the pressure cold, before the first drive of the day.

Skoda Kushaq tyre pressure chart

Kushaq cold tyre pressure
Tyre sizeVariantsFrontRear
205/60 R16Classic+, earlier Active and Ambition33 psi (2.3 bar)33 psi (2.3 bar)
205/55 R17Signature, Sportline, Prestige, Monte Carlo33 psi (2.3 bar)33 psi (2.3 bar)

No confirmed full load Kushaq figure turned up, so none appears above. If five adults and a packed boot are routine for you, look at that B pillar sticker: any higher loaded number Skoda wants will be printed there.

Cold means before you drive

Driving warms the tyres and the trapped air swells. Twenty minutes crawling through Kushaq city commutes can push a Kushaq tyre filled to 33 psi cold up to 35 or 36. Releasing air from a warm Kushaq tyre to hit 33 means it reads around 30 by morning. Check at dawn, or once the Kushaq has rested for three hours. When a pump visit has to happen mid journey, add 2 to 3 psi above 33 and trim it back at sunrise.

Kushaq figures for bar and kPa screens

Some forecourt inflators work in bar or kPa. For the Kushaq, 33 psi lands close to 2.3 bar, or 228 on a kPa display. If the screen moves in 0.1 bar steps, choose 2.3 and do not round down to 2.0, which is closer to 29 psi. Our tyre pressure converter gives the exact number for any unit.

Filling a Kushaq at the petrol pump

  1. Park so the hose reaches all four valves without pulling across the paint.
  2. Remove each Kushaq valve cap and park them in a cup holder for safekeeping.
  3. Dial in 33 and push the chuck square onto the valve until hissing stops.
  4. Wait for the beep, then check the reading with your own gauge.
  5. Lift the boot floor, top up the Kushaq spare as well, and refit every cap.

Forecourt machines can read 2 psi high or low. A pocket gauge in the Kushaq glovebox settles any doubt.

Monsoon, highway and ghat notes

Water on the road lifts a soft tyre off the surface sooner, so keep the Kushaq exactly at 33 through the rains, not lower for comfort. Before an expressway run of several hours, check the pressure cold at home. Coming down a long ghat, Kushaq brakes and tyres both run hot, so give them time to cool before any reading. Never lower pressure on a hot day thinking it will stop a blowout; under inflation builds more heat, not less.

How a Kushaq behaves when pressure drifts

Below 30 psi the turbo petrol Kushaq feels lazy to steer, both front shoulders scrub away early, and fuel use climbs. A 55 profile Kushaq tyre also gets squashed onto the rim flange by a deep pothole, which can crack the alloy. Above about 36 psi the middle ribs go bald sooner, concrete joints on flyovers jolt the Kushaq cabin, and a panic stop on wet tar takes longer.

Ignore the maximum psi cast into the Kushaq sidewall; it states the strongest pressure that casing tolerates, not what to pump in.

Questions owners ask

What is the correct Skoda Kushaq tyre pressure?

Fill each of the four Kushaq tyres to 33 psi, measured cold. That is 2.3 bar. Confirm it against the tag on your own Kushaq B pillar.

Do 17 inch Kushaq trims need different air?

No. Both 205/60 R16 and 205/55 R17 are set to 33 psi front and rear.

Does a fully loaded Kushaq need extra air?

No separate loaded Kushaq number could be confirmed. Read the B pillar sticker or handbook; if Skoda prints a loaded value there, use it whenever the Kushaq is packed.

Does a Kushaq benefit from nitrogen?

Yes. Nitrogen leaks away marginally slower, but the Kushaq target stays 33 psi cold. Ordinary air mixes in safely when no nitrogen point is nearby.

How often should I check Kushaq tyre pressure?

Every second weekend, and again before outstation drives. Even healthy Kushaq tyres seep 1 to 2 psi monthly.