The Baleno tyre pressure that most sources publish is 29 psi, the same number for each front wheel and each rear wheel, taken when the tyres are cold. It holds for the 185/65 R15 fitment of the Sigma and Delta as well as the 195/55 R16 fitment of the three alloy wheel trims.
Swing the driver door wide and read the pillar label, or turn to the tyre page of the owner's manual: if either ever disagrees with a website, go by the car. The large psi figure moulded into the rubber is a ceiling for the tyre itself, never a target for the pump.
Baleno fitment card
- Tyre size
- 185/65 R15 (Sigma, Delta), 195/55 R16 (Zeta, Alpha, Alpha (O))
- Wheels
- 15 inch steel with full cover (Sigma, Delta), 16 inch alloy (Zeta and above)
- Tyre pressure (cold)
- Front 29 psi, rear 29 psi; check the driver door sticker
- Spare
- 185/65 R15 on a 15 inch steel wheel
- Wheel cap
- 15 inch full cover (Sigma, Delta)
- Brakes
- Front disc, rear drum
- Wiper blades
- 21 inch driver side; measure the passenger blade (18 or 19 inch listed)
- Fog lamps
- LED front fog lamps on Alpha and Alpha (O); dealer kits for lower variants

Baleno tyre pressure chart
| Variant | Tyre | Front (cold) | Rear (cold) |
|---|---|---|---|
| Sigma, Delta | 185/65 R15 | 29 psi | 29 psi |
| Zeta, Alpha, Alpha (O) | 195/55 R16 | 29 psi | 29 psi |
| Spare | 185/65 R15 | Keep at least the road figure; top up monthly | |
Unlike some SUVs, this hatch does not ask for a split between axles at normal load, so one number covers all four wheels. A few tyre maker pages list 30 or 32 psi; the 29 psi figure is what most sources and the door labels we have seen agree on. Maruti does not publish a separate full load figure that we could confirm, so this page leaves that column blank. Look on your door label: if it shows a loaded column, use it.
Why the pressure must be read cold
Air expands as a tyre heats up. After twenty minutes on a hot highway the gauge can show 3 or 4 psi above the cold reading, and that is normal. Bleeding a hot tyre back to 29 leaves it soft once it cools. So take readings at dawn, or once the Baleno has stood unused for three hours or more. Topping up mid journey with warm tyres? Set roughly 3 psi above 29, then verify with a gauge when the car has cooled overnight.
29 psi in bar and kPa
Plenty of digital air machines and imported gauges read out in bar or kPa. Converted, the Baleno's 29 psi equals roughly 2.0 bar, near enough 200 kPa. If the machine is set in bar, dial in 2.0 for each corner. For any other number, the psi to bar converter does the maths, for instance if your door label lists a different number for heavy loads.
Filling Baleno tyres at a petrol pump
- Park so the valve of each wheel is easy to reach, with the handbrake on.
- Unscrew each valve cap and keep the caps in your pocket; a missing cap lets dust into the valve core.
- Set the machine to 29 psi and press the nozzle squarely on the valve until it beeps.
- Do all four corners, then open the boot and check the spare under the floor board.
- Refit the caps by hand, without over tightening.
Machines at busy pumps drift out of calibration. A pocket gauge stored in the door bin gives you a second opinion, and the step by step pressure checking guide shows the method.
Highway runs, full load and monsoon
Load a Baleno with five grown ups and weekend luggage and it presses far harder on the rear tyres. Since a full load figure is not published, read the door label first. If it gives only one figure, the safe habit at most service centres is to stay at that figure for city use and not go below it on long trips. Stay below the sidewall's printed limit at all times.
During monsoon weeks, a properly filled tyre holds its tread channels in shape, so they can clear standing water on a flooded flyover. An under filled one flattens and pinches those channels closed. On ghat roads the brakes heat the rims, so recheck pressure cold the next morning rather than at the top of the climb.
Low or high Baleno tyre air pressure: what you feel
Too low: steering turns heavy at parking speed, the car feels lazy in corners, mileage drops and the outer shoulders of the tread wear first. The 195/55 R16 tyre on the Zeta and Alpha has a short wall, so a soft tyre leaves the alloy rim more open to a pothole crack.
Too high: the Baleno starts skipping over expansion joints, the middle band of the tread goes bald early, and braking grip on wet roads drops because less rubber touches the road.
A single tyre that sheds a few psi each week usually hides a screw in the tread or a leaking valve insert. Have it repaired at a tyre shop rather than topping up forever.
Tyre pressure warning and nitrogen
Some Baleno variants show a tyre pressure warning on the cluster. If it lights, stop where safe, look at all four tyres and fill to 29 psi cold. Our tyre pressure warning light page covers how the reset works. Nitrogen filling is optional: it leaks a little slower, but correct air checked every two weeks works just as well.
Questions owners ask
What is the Baleno tyre pressure front and back?
Fill 29 psi on each axle when the tyres are cold, whether your Baleno rides on 15 inch steel rims or 16 inch alloys. The door pillar label confirms it for your car.
Does a Baleno need extra air before an expressway run?
Follow the door label. If the label has a heavy load column, switch to it for a packed car. Otherwise keep to 29 psi cold and never cross the maximum printed on the tyre wall.
What is the Baleno tyre pressure in bar?
Set the machine to 2.0 bar, which matches 29 psi, or about 200 kPa. Set 2.0 on a machine that reads in bar.
Is the Baleno Alpha tyre pressure different from the Sigma?
No. Even though the Alpha runs 195/55 R16 and the Sigma 185/65 R15, the published cold pressure is 29 psi for both.
How often should I check Baleno tyre pressure?
Once a fortnight, and again before any outstation drive, plus the spare once a month. Tyres lose a little air naturally, faster in hot weather.
Why does my Baleno show 33 psi after driving when I filled 29?
Heat from driving pushes the reading up, so seeing 32 or 33 on a warm tyre is expected. Do not release it; check again once the tyres have cooled.