The recommended Alto tyre pressure, measured cold, is 30 psi on every tyre, on the original Alto and Alto LXi with their 145/80 R12 tyres. The figure comes from the owner's manual quoted by owners, and the printed panel on the driver's door pillar gives the value for your own car.
Fill the same air on the front and rear axle. Ignore the bigger figure printed in small letters by the bead, which is the tyre's own limit, far above what an Alto needs.
Alto fitment card
- Status
- Original Alto and Alto LXi no longer sold new; Alto 800 and Alto K10 followed
- Tyre size
- 145/80 R12 on every variant (Std, LX, LXi)
- Wheels
- 12 inch steel on every variant, rim listed as 4J x 12; no factory alloy
- Tyre pressure (cold)
- Front 30 psi, rear 30 psi; check the driver door sticker
- PCD
- 4 x 100 mm, centre bore 54.1 mm (fitment listings)
- Wheel cap
- 12 inch
- Fog lamps
- Not fitted at the factory

Alto tyre pressure chart, normal and full load
| Condition | Front | Rear |
|---|---|---|
| Cold, normal load | 30 psi | 30 psi |
| Full load | See the door sticker | See the door sticker |
The maker's full load figure is missing from every reliable source we checked, so we leave it out rather than guess. Some guides suggest adding a little air for a car full of people and luggage; read the door sticker or the manual before you do. Other websites print 25 or 27 psi for this car. The 30 psi value is the one quoted from the manual and repeated by most sources.
What cold means at a petrol pump
Rolling heats a tyre, and hot air takes up more room. A reading taken after a run across town can be 2 or 3 psi higher than the true cold value. So:
- Take the reading at home after three or four hours of standing still, with your own gauge if you have one.
- If you must use the pump, pick the closest one, ideally just down the road.
- Warm tyres showing 32 are fine; leave them and recheck next morning.
- Refit every dust cap; a gritty valve is a common source of slow air loss.
A hand gauge is easy to use; the pressure checking guide has pictures of each step.
30 psi in other units
Digital pumps sometimes display bar or kPa instead. On those screens, 30 psi shows as about 2.1 bar or 207 kPa. Older manuals print kg/cm², and 2.1 kg/cm² is close to the same figure. Our tyre pressure converter covers any unit an unfamiliar machine shows.
Low air on a small 12 inch tyre
A 145/80 R12 carries the whole car on a small contact patch, so a few psi matter more than on a big SUV. When an Alto runs soft:
- Steering, which has no power assist, feels heavy at parking speed.
- Mileage drops, which owners of this frugal car notice quickly.
- The outer shoulders wear first and the sidewall flexes more, heating the tyre on a long run.
- Rims are more likely to get bent on a pothole edge.
Overfilling an Alto
At 35 or 40 psi the little car skips over speed breakers and grips poorly on wet tarmac, because only the centre of the tread touches the road. The centre then wears faster. On monsoon days, tyres at the right pressure push water out through their grooves better. If you like a slightly firmer feel for a loaded highway trip, check the door label first and keep a wide margin below the sidewall maximum.
Slow leaks and old valves
If one tyre keeps losing 3 or 4 psi a week, the cause is often a nail, a cracked rubber valve, or rust at the rim bead on an older steel wheel. Spray soapy water on the tread and valve and watch for bubbles. Puncture shops plug tread holes within minutes; read about the limits of such repairs on the tyre puncture page. Sidewall damage means a new tyre, and a shop should inspect it.
Questions owners ask
What is the Alto tyre pressure in psi?
It is 30 psi on each tyre, front and back, measured cold. Your own car's panel on the door pillar confirms it.
What is the Alto tyre air pressure for city driving?
Fill 30 psi cold in all four for everyday town driving with a couple of passengers. That keeps the light steering easy and the tread wearing evenly.
Does a loaded Alto need extra air at the back?
We could not confirm a maker full load figure for the original Alto. Go by the door label or the handbook, and never exceed the maximum on the sidewall.
Is 32 psi okay for an Alto?
Two psi extra does no harm, and some owners prefer it for long expressway runs. The ride gets firmer, so return to 30 psi for city use.
Why is the reading higher after a drive?
Warm air expands, so the reading rises. Always set pressure cold, or add the same amount to all four tyres if you can only check them warm.
What pressure for the spare?
Fill it to the same 30 psi or a little more, since it may sit for months. Check it every few weeks.