A wheel cap 14 inch is right only if your tyre sidewall reads R14, because a wheel cap is sized by rim diameter and that number sits right after the R. The same rule gives a 12, 13, 15 or 16 inch cap.
Wrong sizes are the most common return at accessory counters. A cap one size too big will not clip on; one size too small rattles and flies off on the first speed breaker. Here is how to get it right and how to fit it so it stays.
At a glance
- RuleCap size = the number after R on the tyre
- R12 tyre12 inch wheel cap
- R13 tyre13 inch wheel cap
- R14 tyreWheel cap 14 inch
- R15 tyre15 inch wheel cap
- R16 tyre16 inch wheel cap
- Also checkValve slot position, clip style, nut cover clearance
Find your size in ten seconds
- Find a code such as 165/80 R14 moulded into the sidewall rubber.
- Whatever follows the R tells you how many inches across the rim is.
- Buy a cap of exactly that size.
| Tyre code example | Rim | Cap to buy |
|---|---|---|
| 145/80 R12 | 12 inch | 12 inch wheel cap |
| 145/80 R13 | 13 inch | 13 inch wheel cap |
| 165/80 R14 | 14 inch | 14 inch wheel cap |
| 215/75 R15 | 15 inch | Wheel cap 15 inch |
| 215/60 R16 | 16 inch | 16 inch wheel cap |
The first two numbers, the width and the profile, do not matter for the cap. Our tyre code explainer helps if the letters look confusing.
Wheel cap 14 inch: what else to check
Even a correct 14 inch cap can fail to fit if the steel wheel shape is different. Caps are moulded for a pattern of vent holes and a raised centre. Hold the cap against the wheel before paying and see that:
- the notch for the valve sits right over the valve,
- the centre does not touch the wheel nuts,
- the clips reach the rim lip all around.
A model specific cap is designed for those details. A universal cap uses a steel wire ring that adjusts to most steel rims of that size.
12 inch and 13 inch wheel caps for small cars
The smallest hatchbacks use 12 inch caps. The wheel cap for Alto 12 inch rims is a typical example, since that car runs 145/80 R12 tyres. On the current Alto K10 the tyre is 145/80 R13, which means a 13 inch cap. Owners sometimes order by car name alone and get the wrong one, because different generations of the same name used different rims. Always read the tyre first.
15 inch caps for utility vehicles
A wheel cap 15 inch fits rims behind tyres marked R15. The Bolero wheel cap 15 inch is a popular request because that vehicle runs 215/75 R15 tyres on steel wheels. On some utility vehicles the steel wheel carries only a little dome in the middle instead of a full cover. Check which type your wheel has before ordering. For a Bolero wheel cap 15 inch original part, get the part number from the dealer workshop so you get the factory shape and clips.
16 inch wheel caps and larger steel wheels
Bigger steel wheels with R16 tyres appear on base versions of compact SUVs. A 16 inch wheel cap for these is larger and heavier, so the clips carry more load on rough roads. Make sure the cap clears the brake caliper or the balance weights. If a balance weight has been hammered onto the outer lip, the cap may not seat; ask the fitter to stick weights inside the rim instead.
Fitting a cap so it does not fly off
- Clean mud from the steel rim lip.
- Place the wire ring in the cap clips, with its gap near the valve slot.
- Rotate the cover so its cut out is right above the valve stem.
- Hook the top clips in before anything else, then thump your palm around the rim of the cap.
- Tug lightly here and there; a locked cap will not move.
Some owners add two cable ties through the vent holes as a backup on bad roads. Keep them away from the valve and the tyre.
Lost caps: the usual causes
Most lost caps follow a deep pothole or a scrape along a kerb that bends a clip. Heat from the brakes on long ghat descents also softens cheap plastic over time. A cracked clip will not hold, so replace the cap. Replacing one cap is possible, but caps of the same design from different batches can differ in shade. Model pages are listed on the wheel cap hub, and the steel vs alloy guide helps if you are thinking of alloys instead.
Questions owners ask
How do I know if I need a 13 inch or 14 inch wheel cap?
Look at the side of the tyre. If it shows R13, buy a 13 inch cap; if it shows R14, buy a 14 inch cap. The width and profile numbers do not matter.
Will a 14 inch cap work on a 13 inch steel rim?
No. It is too large for the clips to grab and it will drop off. Only an exact diameter match holds.
Do wheel caps fit alloy wheels?
No. Wheel caps are made for steel wheels. An alloy accepts just a little badge sized cover that plugs its middle hole.
Is a universal wheel cap safe?
Yes, if it is the right size and clips on firmly. Check after the first few days of driving that it has not loosened.
Why does my wheel cap make a rattling noise?
The clips or wire ring are loose, or the cap touches the wheel nuts. Remove it, check the clips and refit it with the valve slot lined up.
Are 12 inch wheel caps the same for all small cars?
Not always. The size matches, but the vent holes, valve slot and centre shape differ. A universal cap with a wire ring fits most.
