A Wagon R steering cover from the genuine catalogue is offered in leather or PU. Whichever you pick, it must match the wheel's size and rim thickness.
No two sources gave the same wheel diameter, so put a tape across your own wheel before buying a slip on type.
Wagon R fitment card
- Tyre size
- 155/80 R13 (LXi, LXi CNG), 165/70 R14 (VXi, VXi CNG, ZXi, ZXi Plus)
- Wheels
- 13 inch steel on LXi, 14 inch steel on VXi and ZXi, 14 inch alloy on ZXi Plus
- Tyre pressure (cold)
- 32 psi front and rear on 13 inch tyres, 33 psi on 14 inch tyres
- PCD
- 4 x 100 mm, centre bore 54.1 mm
- Spare
- Steel spare wheel on every variant, including the ZXi Plus
- Wheel cap
- 13 inch (LXi), 14 inch (VXi and other 14 inch steel wheels)
- Battery
- 12 V, 35 Ah
- Earlier version tyres
- 145/80 R13 on lower variants, 155/65 R14 on upper variants

Measuring for a Wagon R steering cover
Stretch a tape over the middle of the wheel, from one outer rim to the opposite one. That is the diameter. Most slip on covers are sold by this number, in centimetres or inches. Then wrap a thread once around the rim to get its thickness. Too loose and it spins in your hands; one that is too tight will not go on without stretching and tearing.
Cover types compared
| Type | Feel | Best for |
|---|---|---|
| Stitch on leather | Close fitting, premium | Owners who keep the car for years |
| PU slip on | Firm grip, easy fit | Most city drivers |
| Silicone or rubber | Soft, cheap to replace | Short term use |
| Fabric or mesh | Cool in summer | Cars parked in the sun |
Stitch on covers fit the rim exactly but take an hour of patient lacing. Slip on covers go on in minutes but add more bulk.
Summer heat and grip
A Wagon R parked in the open on an Indian summer afternoon gets a steering rim hot enough to sting. Light coloured or perforated covers stay cooler than black smooth ones. Sweaty hands slip on glossy plastic in traffic, so a textured grip helps in long jams. Avoid very soft foam covers on the highway; they squash and make the wheel feel vague.
Fitting a stitch on cover
- Wipe the rim and let it dry fully.
- Place the joint where your fingertips wrap, facing you.
- Start lacing at the top, using the needle and thread in the pack.
- Pull each stitch firmly and evenly, working down both sides.
- Tie off at the bottom spoke and trim the thread.
Safety with a Wagon R steering cover
Also keep the horn pad and any steering mounted switches clear and working. After fitting, drive slowly in an empty lane and steer fully left and right to confirm it stays put without bunching. A loose cover is a hazard in a sudden swerve around a pothole or a stray animal.
What to ask for
Tell the parts counter you need a cover for a Wagon R, give the version of the car and the diameter you measured. Ask whether it is leather or PU, and feel the inner lining. A grippy inner lining keeps the cover from turning on the rim.
Other steering cover and Wagon R pages
The steering cover hub explains sizes for all cars, and a sedan example is the Swift Dzire steering cover. For other Wagon R parts, see Wagon R mud flap and Wagon R wiper blade size.
Questions owners ask
Which steering cover size suits a Wagon R?
Measure across the wheel and buy to that number. No confirmed diameter was found, and slip on sizes vary by seller.
Is a leather or PU steering cover better for a Wagon R?
Leather feels better and lasts longer if cared for. PU is easier to clean and handles sweat and heat well. Both are listed in the genuine range.
Can a steering cover block the airbag?
Only if it covers the centre pad. A proper cover wraps the outer rim only, which does not affect the airbag.
Does the same cover fit the old and new Wagon R?
The wheel design changed between versions, so measure your own wheel rather than assume.
How do I clean a Wagon R steering cover?
Leather wants a barely wet cloth with a drop of mild soap, then a dry wipe. Wash a removable PU or fabric cover by hand and let it air dry out of direct sun.