The SX4 wiper blade size is 26 inches for the driver and 14 inches for the passenger, a long and short pairing that differs from many sedans. Here the long right side SX4 blade clears what the driver looks through, and the stubby left one tidies up the corner near the passenger.
With the SX4 no longer sold new, most cars have had several sets fitted over the years. SX4 lengths here are drawn from parts seller fitment data, not a Maruti publication, and one overseas catalogue gives 24 and 16 inch, so check your current SX4 blades with a measuring tape before paying. Measuring, fitting and wear signs follow.
SX4 fitment card
- Tyre size
- 195/65 R15 (VXi, VDi), 205/60 R16 (ZXi, ZDi)
- Wheels
- 15 inch steel on lower variants, 16 inch alloy on ZXi and ZDi
- Tyre pressure (cold)
- 33 psi front and rear in most guides; door sticker gives the exact figure
- Wiper blades
- 26 inch driver side, 14 inch passenger side
- Status
- No longer sold new

SX4 wiper blade size for both sides
| Position | Length | In millimetres |
|---|---|---|
| Driver side (right) | 26 inch | about 650 mm |
| Passenger side (left) | 14 inch | about 350 mm |
Every SX4 trim from VXi to ZDi uses this pair, since the windscreen and arms never changed between variants. Counters that stock SX4 parts usually keep the 26 and 14 inch combination together.
Measuring the blades on your SX4
- Raise the right hand SX4 wiper arm; it holds itself upright once lifted.
- Hold the tape against the SX4 rubber insert alone, skipping the frame; every 25 mm is roughly an inch.
- Check the blade body for a moulded length figure.
- Do the left hand arm next.
- See how blade and arm connect, whether a J hook or another clip, and buy blades with that fitting or the correct adaptor.
A 24 inch reading on the right suggests an earlier buyer chose shorter. Going to 26 inches clears more glass; just confirm the tip stops short of the pillar trim when the SX4 wiper reaches its outer limit.
Fitting new blades on an SX4
Cushion the SX4 windscreen with a folded cloth first, because a bare arm snapping down under spring force can crack glass. Press the small latch at the SX4 blade joint, slide the old blade towards the pivot until the hook releases it, and lift it clear. Feed the fresh SX4 blade onto that hook, pulling till it seats audibly. Lower the arm onto the cloth, slip the cloth out, then do the left side. A short washer squirt confirms both blades sweep evenly and touch along their full length.
Framed, flat or hybrid: which suits an SX4
Conventional SX4 blades use a steel bridge pressing at several points. Flat designs hide a curved spring steel spine inside the rubber, spreading pressure more evenly and resisting lift on the expressway. Hybrids wrap a frame in a plastic cowl. Each style works on this car if length and connector match. Flat ones carry a higher price, yet the rubber compound decides wiping quality more than the shape.
When SX4 blades need changing
- Smears or a greasy haze trailing each SX4 stroke.
- A judder or chatter as the arm travels.
- Rubber edges turned stiff, split or frayed.
- An unwiped band in the middle, usually from a twisted arm or frame.
Summer sun bakes rubber hard on Indian roads, so treat your SX4 to a fresh pair in late May, ahead of the first heavy rain. On long summer parking, lift the arms or find shade.
Looking after the windscreen and blades
Dry wiping on a dusty SX4 screen grinds arc shaped scratches into the glass, so always squirt washer fluid first. Top up the SX4 washer bottle with screen wash diluted as its label says; kitchen detergent leaves a smeary layer. At every SX4 wash, wipe each rubber lip using a wet rag. Poor visibility that stays even with new blades suggests a pitted windscreen, which a glass specialist should assess, because heavy rain with a blurred view is genuinely dangerous.
Other SX4 and wiper pages
Tyre sizes by variant are on SX4 tyre size. Honda's sedan shares the 26 and 14 inch pairing, as Honda City wiper blade size shows, whereas Ciaz wiper blade size lists 24 and 16 inch. Our wiper blade size chart gathers lengths for dozens of models.
Questions owners ask
Are SX4 wiper blades the same on both sides?
No. The right hand blade is 26 inches and the left one is 14 inches, so buy a mixed pair.
Is a 24 inch driver blade acceptable on an SX4?
It clips on but leaves more glass unwiped. Since one overseas catalogue lists 24 and 16 inch, measure the SX4 blades you have and pick the longest one that clears the pillar.
Does the SX4 have a rear wiper?
No. As a three box sedan it has only the two front blades to replace.
How often should I change SX4 wiper blades?
Yearly is typical, best timed just ahead of the monsoon. Replace them earlier if they smear, judder or skip patches.
Do I need to replace the whole arm?
No, only the blade, unless the arm is bent or its spring is weak. A weak arm lets the blade lift at speed even when the rubber is new.