Skip to content
AutoTyreSize Decode a size

Maruti S Presso Tyre Size for Every Variant

Quick answer145/80 R13 on Std and LXi; 165/70 R14 on VXi, VXi Plus, AGS and VXi CNG

Tyre sizes145/80 R13165/70 R14Steel wheelsChecked 13 Nov 2026

Independent owner guide. Not affiliated with Maruti Suzuki. Figures checked against the maker's published details; confirm on your vehicle's door sticker or manual.

The S Presso tyre size hinges on which trim you own: Std and LXi cars sit on 145/80 R13 tyres, while the VXi, VXi Plus, the AGS automatics and the VXi CNG use 165/70 R14. Just two sizes exist across the lineup, and the rim diameter stamped on your wheel decides which one you ask for.

This tall little hatch is built for crowded lanes and broken roads, so its tyres carry a lot of sidewall. That cushion is the reason the car shrugs off speed breakers, and it is worth keeping when you buy replacements. Below you will find the size for each variant, what the numbers mean, safe upsizes with the maths shown, and the signs that a set is due.

S-Presso fitment card

Tyre size
145/80 R13 (Std, LXi), 165/70 R14 (VXi, VXi Plus, AGS and VXi CNG)
Wheels
13 inch steel on Std and LXi, 14 inch steel with full cover on VXi and above
Factory alloys
None; a 14 inch diamond cut alloy is sold as a genuine accessory
Tyre pressure (cold)
Read the sticker inside the driver door; figures vary across guides
Wiper blades
Two front blades; measure the old blades tip to tip before buying
Close up of a 14 inch steel wheel with a full plastic cover and a small hatchback tyre sidewall in a service bay
VXi and higher trims run 165/70 R14 tyres on 14 inch covered steel wheels

Maruti S Presso tyre size by variant

VariantFrontRearWheel
Std, LXi145/80 R13145/80 R1313 inch steel
VXi, VXi Plus165/70 R14165/70 R1414 inch steel, full cover
VXi AGS, VXi Plus AGS165/70 R14165/70 R1414 inch steel, full cover
VXi CNG165/70 R14165/70 R1414 inch steel, full cover

Any given S Presso uses one size on every wheel, so rotating the tyres front to back is simple. The front pair steers and drives this small hatch, which makes their shoulders wear first. Swap them with the rear pair at every second service and the set lasts noticeably longer.

S Presso VXi tyre size versus the LXi

Owners often ask why the S Presso VXi tyre size differs from the LXi. Maruti Suzuki moved the VXi and higher trims to a 14 inch wheel with a 165 mm wide tyre, while the entry Std and LXi keep a 13 inch rim with a slimmer 145 mm tyre. The wider rubber puts more tread on the road, which helps braking on wet tar and steadies the tall body on a flyover bend.

The narrow 13 inch tyre has its own strengths. It rolls easily, steers lightly in parking lots and is usually the less expensive tyre to replace, because the 13 inch size is made in huge numbers for small hatchbacks. If you bought an LXi and want the VXi look, the full step is a 14 inch wheel plus the 165/70 R14 tyre, not a 14 inch tyre squeezed onto a 13 inch rim, which is impossible.

What 145/80 R13 and 165/70 R14 mean

  • 145 or 165: tyre width in millimetres across the widest point.
  • 80 or 70: sidewall height, given in percent of the tread width. On 145/80 the wall is about 116 mm tall; on 165/70 it is about 115.5 mm, almost identical.
  • R: the casing plies run across the tyre, the radial build found on today's cars.
  • 13 or 14: the rim's diameter, given in inches.

Beside the size, each S Presso tyre carries a load rating code plus a speed letter. These vary between the firms that supply Maruti, so we have not listed them. Copy the pair from your present factory tyres, and refuse any replacement whose load code is smaller.

Upsizing without upsetting the speedometer

For this hatch, keep a replacement's height inside a 3 percent band either way. Diameter is the rim in millimetres plus two sidewalls.

SizeSum in mmVersus stock
145/80 R13 (Std, LXi)330 + 2 x 116 = 562base for 13 inch cars
155/80 R13330 + 2 x 124 = 578about 2.8 percent taller
165/70 R14 (VXi stock)356 + 2 x 115.5 = 587base for 14 inch cars
175/65 R14356 + 2 x 114 = 584about 0.5 percent smaller
175/60 R15381 + 2 x 105 = 591about 0.7 percent taller

Only the factory 14 inch package is proven on this body. On a full S Presso, fatter rubber risks scuffing the plastic arch liner during a tight U turn. Ask for a lock to lock check in the shop before money changes hands, and keep your insurer informed.

Spare tyre and puncture habits

When four new tyres arrive, remember the fifth one under the boot board, since rubber ages even when it never turns. Its sidewall shows when it was made, as a four digit code. A spare older than about six years should be replaced even if the tread looks fresh. Keep it inflated a little above the running pressure, since it leaks slowly over months.

The S Presso uses tubeless tyres, so a nail often holds air for a while. Creep along to a roadside repairer for an outside plug or an inside patch. Sidewall slashes are beyond safe repair, and such a tyre has to go. Our tyre puncture repair guide explains which damage is fixable.

When your S Presso needs new tyres

  • Grooves worn level with the raised wear bars inside them, or under about 2 mm deep.
  • Fine crazing on the sidewall after seasons of open air parking.
  • A bubble on the side, usually left by a pothole strike. Take that tyre off and let a tyre specialist examine it.
  • The S Presso drifts left or right, or the wheel trembles on the expressway even after balancing.

If the inside edge of the front tyres wears faster than the outside, book a wheel alignment. Small hatchbacks that climb a lot of high kerbs often knock the toe setting out.

Other S Presso pages and similar small cars

Thinking about alloys? Our S Presso alloy wheels page covers the genuine 14 inch accessory wheel and aftermarket choices. Monsoon blade tips: S Presso wiper blade size. Smaller and larger Maruti siblings are on the Alto K10 tyre size page and the Celerio tyre size page, and the full index is our car tyre size hub, arranged alphabetically.

Questions owners ask

What is the S Presso tyre size?

Std and LXi models use 145/80 R13; the 165/70 R14 belongs to the VXi, VXi Plus, AGS automatics and the VXi CNG. All four wheels on a given car match.

What is the S Presso wheel size?

Std and LXi cars use 13 inch steel wheels. From VXi upward the rim grows to 14 inches, still steel, hidden by a plastic cover. No variant comes with factory alloys.

What is the S Presso VXi tyre size?

The VXi takes 165/70 R14, the same as the VXi Plus and the AGS versions. It is wider than the 145/80 R13 tyre on the LXi.

Is it possible to run VXi size tyres on an S Presso LXi?

Only if you change the wheels to 14 inch rims as well. There is no way to mount a 14 inch tyre on the 13 inch LXi rim. The bigger package is around 4 percent taller, which makes the speedo show slightly less than true speed.

Is the CNG S Presso on special tyres?

No. The VXi CNG uses the same 165/70 R14 tyre as the petrol VXi. With the gas tank occupying the boot, the rear axle carries more weight, so hold pressure at the door sticker value.

How long do S Presso tyres last?

Many owners get a long run from the factory set in mixed city use, but tread depth and age matter more than distance. Replace tyres at the wear bars or when the sidewalls crack, whichever comes first.