Skip to content
AutoTyreSize Decode a size

NS 200 Battery Size and Replacement

Quick answer12 V 8 Ah sealed VRLA battery, per the owner's manual

Bike gearVRLAMaintenance freeCheck the old labelChecked 13 Nov 2026

Independent owner guide. Not affiliated with Bajaj. Figures checked against the maker's published details; confirm on your vehicle's door sticker or manual.

The NS 200 battery size is a 12 volt, 8 Ah sealed VRLA (valve regulated lead acid) battery, the maintenance free type, per the battery data in Bajaj's NS200 manual. One Bajaj export page lists 9 Ah, so check your old battery and match it, or go one step higher only when the box still sits in the holder.

The NS200 is fuel injected and has a digital console, so it needs steady voltage to start cleanly. A weak battery shows up as slow cranking in winter mornings long before it dies completely.

Pulsar NS200 fitment card

Front tyre
100/80-17 tubeless
Rear tyre
130/70-17 tubeless
Wheels
17 inch alloy, front and rear
Battery
12 V, 8 Ah, VRLA (sealed, maintenance free)
Tyre pressure (cold)
See the owner's manual or the sticker on the swingarm
Small sealed 12 V motorcycle battery sitting in its tray under the seat of a sport bike with a rubber strap
A small sealed 12 V battery under the rider seat, held by its rubber strap

NS 200 battery size at a glance

ItemSpecification
Voltage12 V
Capacity8 Ah (owner's manual)
TypeVRLA, sealed, maintenance free
WhereUnder the rider seat

The physical size of the box matters as much as the rating. The new battery must sit in the tray with the strap closed and the posts placed exactly like the old unit's, or the cables will be stretched.

How to check your NS200 battery

  1. Remove the rider seat with the key.
  2. Find the printed label on the battery case: volts, Ah and model code.
  3. Mark where the red positive post and the black negative post sit.
  4. Photograph the label and take it to the parts shop.

With a multimeter, a healthy battery reads about 12.6 to 12.8 V with the bike off. Below 12.4 V it needs charging; below about 12 V after a full charge it is likely worn out.

Signs the NS 200 battery is weak

Common signs: the starter clicks or turns slowly; the console resets or flickers while cranking; the horn sounds weak at idle; the bike starts with the kick of a push but not on the button. Fuel injected bikes need a minimum voltage to run the pump and the ECU, so a weak battery can cause starting trouble even when the engine spins.

Before blaming the battery, check the terminals for loose bolts or white corrosion. A wire brush and a tight bolt fix many no start calls.

Replacing the battery step by step

  1. Turn the ignition off and remove the seat.
  2. Undo the negative (black) terminal first, then the positive (red).
  3. Release the strap and lift the battery out upright.
  4. Drop in the replacement, 12 V with the same footprint and post layout.
  5. Bolt the red cable on first, the black one last, both snug.
  6. Close the strap and refit the seat.

Keep tools from bridging the posts or touching the frame while the red cable is on; a short can weld a spanner and scorch wires.

Higher Ah or lithium for an NS200

A slightly higher Ah battery of the same size and voltage is fine and gives more cranking reserve, but it does not make the charging system stronger. Lithium batteries are lighter and hold charge longer when parked, but they need a charging system and charger suited to lithium, and they cost more. Lithium is weighed up against lead acid in lithium ion battery for bike.

Keeping the battery healthy

Short city rides with the headlamp always on drain more than they charge. Take a 20 minute ride at least once a week. Parking for a fortnight or longer? Hook up a smart charger; see bike battery charger. Avoid adding high wattage auxiliary lamps or loud horns without a relay, as they strain the battery and the regulator.

Old lead acid batteries contain acid and lead. Return them to the battery shop for recycling, never throw them in household waste.

Other NS200 and battery pages

For tyres, see NS 200 tyre size. The bike battery hub lists other models, such as the Pulsar 220 battery size and Pulsar 150 battery size. If your bike still fails to start with a new battery, have the charging system tested by a mechanic; a failed regulator rectifier will kill a new battery within weeks.

Questions owners ask

What is the ns 200 battery size?

A 12 V, 8 Ah sealed VRLA battery as listed in the owner's manual. Confirm against the label on your old one.

Is a 9 Ah battery okay for the NS200?

Yes, if it is 12 V, the same box size and the same terminal layout. One Bajaj export page lists 9 Ah for this bike.

Where is the battery on the NS200?

Under the rider seat. Unlock the seat with the key to reach it.

How long does an NS200 battery last?

Usually a few years, depending on use. Short rides, long parking and extra electrical loads shorten it.

Should I add distilled water to the NS200 battery?

Never. This VRLA unit is sealed for life, and prising the vents open ruins it.