The Honda Unicorn 150 battery size on the earlier CB Unicorn 150 is 12V 7 Ah, while the current Unicorn with the 160 cc engine uses a smaller 12V 4 Ah maintenance free battery. The two are not interchangeable without checking the case size and the battery tray.
Because the bike has been updated several times, the safest step is to look at the sticker on whichever battery your Unicorn carries now. It shows the volts, Ah rating and size code that the parts shop needs.
Unicorn fitment card
- Front tyre
- 80/100-18 tubeless
- Rear tyre
- 100/90-18 tubeless
- Wheels
- 18 inch alloy, front and rear
- Pressure, solo (cold)
- Front 25 psi, rear 29 psi
- Pressure, with pillion
- Front 25 psi, rear 33 psi
- Battery
- 12V 4 Ah maintenance free (current 160 cc model)
- Earlier CB Unicorn 150
- Front 2.75-18, rear 100/90-18, battery 12V 7 Ah

Honda Unicorn 150 battery size and later versions
| Version | Battery | Type |
|---|---|---|
| CB Unicorn 150, earlier version | 12V 7 Ah | Conventional on many bikes |
| Unicorn, current 160 cc | 12V 4 Ah | Maintenance free |
Between these two, Honda sold an updated Unicorn 150. We could not confirm its battery from two sources, so read its label before buying.
Finding and reading the unicorn bike battery
- Turn off the ignition and take out the key.
- Remove the side panel on the left side of the bike, below the seat. On some versions you lift the seat first; the owner's manual shows how.
- Read the printed volts, Ah and size code on the battery case.
- Note the terminal positions and, on an older battery, whether it has filler caps and a vent tube.
A battery with screw caps and level marks is the conventional type that needs distilled water. A sealed one with no caps is maintenance free.
Switching an old Unicorn 150 to maintenance free
Many owners of the earlier Unicorn 150 move to a sealed battery to stop topping up water. That works if the new battery has the same voltage, close to the same Ah, fits the tray and lines up with the cables. Ask the shop to remove the old vent tube or clip it safely. Keep the Ah close to 7; a much smaller battery may not support the self start on a cold winter morning.
Signs a Unicorn battery is failing
- The self start cranks slowly, but the bike starts on the kick.
- The horn goes weak or the indicators blink slowly at idle.
- On older bikes, low electrolyte or white powder on the terminals.
- The battery case looks swollen. Have it checked at a service centre right away.
A bike used for short office runs with the headlamp on may never fully charge. A longer ride once a week, or a charger, helps. Our bike battery charger page explains how to use one at home.
Changing the battery yourself
Black lead off first, red lead second. Lift out the old battery and clean any corrosion on the cable ends with a dry brush. Seat the new battery, reattach red before black, and cover the positive terminal with its boot. Refit the side panel so it clips in fully; a loose panel rattles on rough roads.
Questions owners ask
Which battery does the unicorn bike use today?
The current Unicorn with the 160 cc engine uses a 12V 4 Ah sealed battery. Confirm with the label on your bike.
Can I put a 12V 4 Ah battery in my old Unicorn 150?
It may fit the tray, but it stores much less charge than the 7 Ah original. The self start can struggle, especially in winter. Stay close to 7 Ah on the older bike.
Does the Unicorn 150 battery need distilled water?
A conventional battery with filler caps does. Check the level every month and top up only with distilled water. A sealed maintenance free battery needs none.
Why does my Unicorn battery drain while parked?
A failing battery, a fitted accessory such as an alarm or a mobile charger left connected, or a faulty rectifier can drain it. Have the charging voltage tested at a service centre.
How long does a Unicorn battery last?
Typically two to four years. Heat, long periods without riding and short trips shorten its life.