Skip to content
AutoTyreSize Decode a size

Honda Brio tyre size for every variant

Quick answer175/65 R14 on every Brio variant, on 14 inch steel or alloy wheels

Tyre sizes14 inch wheelsSame size, every trimChecked 13 Nov 2026

Independent owner guide. Not affiliated with Honda. Figures checked against the maker's published details; confirm on your vehicle's door sticker or manual.

The Honda Brio tyre size never changes from 175/65 R14, from a plain E on steel rims right up to a VX automatic on alloys. Honda never changed it, so even an early Brio takes the same tyre as the last one built.

Honda has stopped selling the Brio new, yet thousands still run around Indian cities as first cars and second family cars. Because it is light and short, the little Honda is easy on tyres, yet owners still face the usual trouble: potholes that pinch a sidewall, a slow leak from a screw collected beside some half built flyover, or a shop that tries to sell a size the car never wore. Here is the full picture.

Brio fitment card

Tyre size
175/65 R14 on every variant
Wheels
14 inch steel (E, S), 14 inch alloy (VX, VX AT)
Tyre pressure (cold)
Printed on the driver door pillar sticker; listings disagree, check it there
Status
No longer sold new; figures are for the last version
Small hatchback front wheel with a 14 inch steel rim and a radial tyre in a tyre shop bay
A 14 inch steel wheel with a tall sidewall tyre on a small city hatchback

Brio tyre size by variant

Honda Brio tyre and wheel by variant
VariantFrontRearWheel
E (base model)175/65 R14175/65 R1414 inch steel, centre caps
S175/65 R14175/65 R1414 inch steel, full wheel covers
VX and VX AT (top model)175/65 R14175/65 R1414 inch alloy
Earlier version (E, S, V, VX)175/65 R14175/65 R1414 inch steel or alloy

The only thing that changes between Brio trims is the wheel underneath. On the E you see bare steel with a small hub cap, the S hides its steel rims under full plastic covers, and the VX gets alloys. The tyre itself, 175/65 R14, stays put on all of them, manual or automatic.

What 175/65 R14 tells a Brio owner

Read it left to right. Brio tyres are 175 mm across the section. Then 65: each Brio sidewall reaches 65 percent of that width, near 114 mm. The R means radial plies, and 14 matches the rim in inches. Stack those and the complete Brio tyre measures about 583 mm top to bottom.

That fairly tall sidewall is a friend on Indian streets. It cushions cracked tar and clumsy speed breakers better than a low profile tyre would, and it shields the rim a little when a flooded pothole hides under monsoon water. We have not confirmed one load index and speed symbol for every factory tyre, so note the code beside the size on the Brio's present tyres (two digits and a letter) and never accept a lower one.

Bigger tyres for the Brio: the numbers

Owners often want a wider look or a little more grip. Our shop rule: a Brio upsize may shift total height by about 3 percent at most.

Brio upsize options compared
SizeOverall diameterChange vs 175/65 R14
175/65 R14 (stock)about 583 mm0
185/65 R14about 596 mmabout 2.2 percent taller
185/55 R15about 585 mmabout 0.2 percent taller
185/60 R15about 603 mmabout 3.4 percent taller, too much

A 185/65 R14 mounts on Honda's own rim and is the change Brio owners ask for most. It rides slightly softer and fills the arch a bit more, but ask a helper to wind the Honda's wheel fully over in each direction, listening for liner scraping. The 185/55 R15 needs 15 inch wheels Honda never offered on this car, so you would be ordering aftermarket alloys matched in PCD, bore and offset. That option sharpens steering but brings a firmer ride on rough roads. Inform the insurance company about a wheel swap, and hold on to the Honda rims in case a claim or resale needs them.

Spare wheel and the Brio boot

The Brio's spare lives beneath its boot board, normally a 14 inch steel wheel. Check the size on that spare too, because it may be the only tyre on the car that has never been changed and could be very old even with full tread.

When you replace all four road tyres, bring the spare into rotation only when it matches in size and is still young. Otherwise let it stay as an emergency wheel and put a gauge on it monthly, because a soft spare leaves you stuck on an unlit highway.

Air pressure on the little Honda

The sources we checked do not agree on the Brio's cold pressure, so this page gives no number for it. Honda put the right front and rear values on a label stuck inside the driver's door frame, with the same values again in Honda's handbook. Fill to that label while the Brio is cold, which means using a pump close to home.

Skip the figure moulded on the Brio's tyres. That moulded figure is a safety ceiling, not what this car needs. Pump gauge tips sit in our car tyre pressure article, and bar or kPa become psi in the tyre pressure converter.

When the Honda Brio tyre size needs fresh rubber

  • Grooves worn to the Brio's 1.6 mm indicator bars
  • Front edges going bald before the centre, a hint of bad alignment or chronic low air
  • Fine splits on the walls of a Brio parked out in the sun for years
  • A bubble or cut on the side wall: limp slowly to a puncture wala or tyre dealer for a verdict, and do not carry on using it
  • A date code showing roughly five years, even on a car that rarely moves

City Brios usually wear the front pair first because the front wheels do the steering and driving. Moving the front pair to the back around each 10,000 km evens it out, and a fresh set deserves an alignment reading on the day it goes on. Our wheel alignment page explains what the machine checks.

Shopping for Brio tyres

Plenty of Indian hatchbacks share 175/65 R14, so you will find it at almost any tyre shop and in many tread patterns. For mostly city driving, a comfort tyre with a quiet tread suits the Brio's light weight. For Brio owners who load up the family for long highway runs, choose one with a strong sidewall and good wet grip ratings from a reputable tyre maker.

Fitting all four from the same range keeps braking even. If you only replace two, put the new ones on the rear, where losing grip is harder to catch in the wet. Brio rivals and other small cars fill our car tyre size pages; start with the Swift tyre size breakdown.

Questions owners ask

What is the Brio tyre size?

Every Brio uses 175/65 R14. The base E and the S have steel wheels, while the VX and VX automatic have alloys, but the tyre size is the same.

Does the Brio VX use a bigger tyre than the E?

No. The VX gets 14 inch alloy wheels instead of steel, but both run 175/65 R14 tyres.

Will 185/65 R14 go on a Honda Brio?

Yes, many owners run it. It stands about 2.2 percent taller and sits on the Honda rim. Check that the tyre does not rub at full steering lock.

Does the Brio take tubeless tyres?

Yes. Honda fitted tubeless radials in 175/65 R14. Use a tubeless valve and get punctures plugged or patched by a shop.

What air pressure should a Brio run?

Use the figure printed in the Brio's door frame label or handbook, measured cold. The sidewall number is only the maximum.

Is the Brio still sold new?

No, Honda no longer sells the Brio new in India. Its 175/65 R14 size stays common, since lots of small cars share it.