The Destini 125 tyre size on the latest scooter is a 90/90-12 steering tyre teamed with a 100/80-12 driven tyre, since Hero moved it to 12 inch alloys at both ends. Older Destini 125 and Destini 125 XTEC scooters roll on 90/100-10 tyres, identical front and back, fitted to 10 inch wheels.
Step one at any tyre counter, then, is knowing which wheel your Hero Destini carries, because 10 and 12 inch rubber cannot be swapped. Further down we show how to tell the generations apart, which cold pressures to use alone or with a passenger, and the wear signs worth watching on a family scooter that hauls two people and groceries daily.
Destini 125 fitment card
- Front tyre
- 90/90-12 tubeless (current 12 inch model)
- Rear tyre
- 100/80-12 tubeless (current 12 inch model)
- Wheels
- 12 inch alloy front and rear
- Earlier Destini 125
- 90/100-10 front and rear on 10 inch wheels
- Tyre pressure (cold)
- Front 22 psi, rear 29 psi solo, rear 36 psi with pillion
Destini 125 tyre size by version
| Variant | Front | Rear | Wheel |
|---|---|---|---|
| Destini 125 (current) | 90/90-12 | 100/80-12 | 12 inch alloy |
| Destini 125 and XTEC (earlier) | 90/100-10 | 90/100-10 | 10 inch |
Check the final figure in the code on your tyre. A 12 means the newer scooter, which needs a different size at each end. A 10 means the older one, where both tyres match and could even trade places to balance their wear.
Why the move to 12 inch wheels helps
Larger hoops roll across broken road patches and expansion gaps with a softer thud, and they settle the scooter at higher speeds. The new front measures about 467 mm tall and the rear about 465 mm, compared with roughly 434 mm for the old 90/100-10. The rear also gained a 100 section, handy when riding two up with a loaded under seat boot. You cannot just bolt 12 inch wheels onto a 10 inch Destini, though; its fork, brakes and body panels were designed around the smaller wheel.
Reading 90/90-12 and 100/80-12
- 90 and 100: how many mm wide each Destini tyre is.
- 90 and 80: the profile ratio. On this Hero that gives about 81 mm of sidewall up front and 80 mm out back.
- The dash: bias ply build, normal for scooters.
- 12: rim diameter, in inches.
Our sidewall reading guide decodes load and speed markings.
Air pressure, solo and with a pillion
Spec listings for the Destini 125 show these cold figures:
| Load | Front | Rear |
|---|---|---|
| Rider only | 22 psi | 29 psi |
| Rider and pillion | 22 psi | 36 psi |
One listing puts the solo rear at 28 psi, and these numbers were published for the XTEC, so cross check them against your Destini's printed handbook. The rear goes up with a passenger because that weight sits right above the back wheel. Pump machines at fuel stations often misread on tiny scooter valves; a pocket gauge settles it. See our two wheeler pressure page for more.
When the Destini needs new tyres
- Grooves have worn down level with the little raised indicators inside them.
- The scooter skates or feels twitchy on wet tarmac when the monsoon starts.
- Upright city commuting has worn a flat strip down the centre of the back tyre.
- Cracks, slits or a swelling on the flank. Ease the Destini to a tyre dealer at walking pace for a proper look.
Buy for the rim you actually have; a 10 inch tyre and a 12 inch rim simply do not mix, in either direction.
Puncture care for scooter tyres
Both generations run tubeless, so a nail normally means a gradual loss of air instead of an instant flat. Plenty of roadside repairers plug a tubeless scooter tyre while it stays on the Destini. If the hole sits close to the flank or is larger than a nail, fit a new tyre instead. Plugs and patches are compared on our puncture repair page.
Other 125 cc scooters
Shopping for a new 125? Compare the Access 125, Jupiter 125 and Activa 125 sizing pages, or open the two wheeler tyre size hub for motorcycles too.
Questions owners ask
Hero Destini tyre size: which do I need?
Newer Destini 125 scooters take 90/90-12 up front and 100/80-12 behind. Older Destini 125 and XTEC models take 90/100-10 at both wheels.
How can I tell a 10 inch Destini from a 12 inch one?
Check the size code on your tyre. Ending in -12 means 12 inch wheels; ending in -10 means the older 10 inch setup.
Can an older Destini 125 take 12 inch wheels?
Not as a simple swap. Its fork, brakes and body suit the original 10 inch wheels, so keep buying 90/100-10 tyres.
Destini 125 pressure with a passenger?
With a passenger, listings give 22 psi (front) plus 36 psi (rear); alone, 22 psi (front) plus 29 psi (rear). Your handbook has the final word.
Is the Destini 125 tyre tubeless?
Yes. Both the 10 inch and 12 inch generations use tubeless tyres.
Do both wheels on the new Destini share a size?
No. The front takes 90/90-12 while the rear takes the broader 100/80-12.